Does it work if you add on the 192.168.1.4 machine a route:
Why don't you simply assign an address from the 192.168.1.x range to the VPN client ?
You are using tap device, so bridging should work.
From: openvpn-users-bounces@xxxxxxxxxxxxxxxxxxxxx on behalf of probsd org
Sent: Tue 31-Jul-07 16:53
Subject: [Openvpn-users] Routing
Hey Group, I have a pretty simple setup. My internal LAN is a 192.168.1.x 255.255.255.0 network. The OpenVPN server is running on 192.168.1.2 and the virtual IP is 10.3.0.1
I can connect to the VPN fine and use VNC and I can ping 192.168.1.2 just fine. However, I cannot ping 192.168.1.4 which I need to get to.
Below is my server and client conf files. I also have set the following in my Linksys Router routing table
Destination LAN IP: 10.3.0.0
Gateway IP: 192.168.1.2
server 10.3.0.0 255.255.255.252
push "route 192.168.1.0 255.255.255.0"
keepalive 10 120
tls-auth ta.key 0
remote 220.127.116.11 1194
route 192.168.1.0 255.255.255.0 vpn_gateway 3
tls-auth ta.key 1
Be a better Heartthrob. Get better relationship answers from someone who knows.
Yahoo! Answers - Check it out.