well a little addition:
I found the route table changes
only 1-2 secs after the script finished. I’ve checked the bridge-start
srcipt and run the commands one by one to check which command changes the route
table. However if I run the script’s commands one by one finally the
route table doesn’t changes! Although now the eth0 IP address disappear
from the ifconfig’s reason… interesting… I got 2 different
problem when I run the commands from script and one by one. J
From: openvpn-users-bounces@xxxxxxxxxxxxxxxxxxxxx
[mailto:openvpn-users-bounces@xxxxxxxxxxxxxxxxxxxxx] On Behalf Of Csige
Sent: Monday, October 01, 2007 4:57 AM
To: openvpn-users@xxxxxxxxxxxxxxxxxxxxx
Subject: [Openvpn-users] start-bridge script overwrites route table
Hi
I’ve tried to set up an openvpn server on a FC7 linux
server in bridging mode. I’ve read the howtos and examples and so on but
may be I don’t really understand the real point of it. I’ve set up
everithing but the problem seems are not in the configuration files because
problems starting when I start bridge-start script as it overwrites the route
table and sets the default gateway to the br0 interface. Therefore every
traffic which earlyer went to the ppp0 interface (which was the def gateway)
and to the internet now goes to the br0 interface and doesn’t reach the
internet. Is this normal? Could somebody pls give me some hint what
did I not understand?
very thanks and
best regards